Floor, power and a way in. Plan on about 10×10 ft per station, two dedicated 120V/20A circuits, and a dock or elevator the road cases can use. We bring everything else. At the Seattle Convention Center the power is ordered through the venue and load-in runs on a marshalling schedule, so we need that window in writing. A hotel ballroom or a South Lake Union office floor is usually simpler.
The short checklist
- Power: two dedicated 120V/20A circuits per station. At the Convention Center that means an electrical order placed ahead of time. In a hotel it usually means checking the circuit isn't shared with catering.
- Floor: roughly 10×10 ft for each station, level, with room in front for a line that doesn't block an exit or an aisle.
- Access: a freight dock and a service elevator we can book. Downtown towers and SLU office buildings nearly always route gear this way, so reserve the elevator for our setup window.
- Time: a load-in slot before doors. The kit arrives as freight from Fullerton, 976 straight-line miles away, so a firm slot matters more here than it would for a local job.
- Cover outdoors: a roof, a tent or an awning over the station, plus a power source within reach. Blanks and transfers have to stay dry.
What we bring
Presses, heat presses, ink, blanks in XS–4XL, tables, signage and the crew who run it. You don't rent anything for us. If the venue is somewhere less standard, like a Fremont studio, a Ballard taproom or a SoDo warehouse, send photos or a floor plan and we'll flag power or access problems before we quote.
The two things that most often hold up a Seattle setup are an elevator nobody booked and a circuit shared with a coffee station. Both take one email to sort out ahead of time.